Review Board 1.7.16


libpri: Add control of inband audio progress indication ie to the SETUP_ACKNOWLEDGE message.

Review Request #3520 - Created May 1, 2014 and submitted

rmudgett
1.4
AST-1338
Reviewers
asterisk-dev
LibPRI
This review and https://reviewboard.asterisk.org/r/3521/ work together to allow Asterisk to control the inband audio available progress indication ie on the SETUP_ACKNOWLEDGE message when dialtone is present.

Added support to the libpri API to control the inband audio available progress indication ie on the SETUP_ACKNOWLEDGE message.

* Added the progress indication ie progressmak value to the struct pri_event_setup_ack so the PRI_EVENT_SETUP_ACK event can indicate when a SETUP_ACKNOWLEDGE comes in with inband audio (ie dialtone).

* Added pri_setup_ack() so when the SETUP_ACKNOWLEDGE message is sent it can indicate if inband audio is present (ie dialtone).
Sent calls over an ISDN trunk with overlap dialing enabled that did and did not present dialtone for more digits.
Observed that the inband audio available progress indication ie was sent when needed on the SETUP_ACKNOWLEDGE message.
Added a debug message that indicated when Asterisk did and did not receive the inband audio indication for the SETUP_ACKNOWLEDGE message.
Review request changed
Updated (May 12, 2014, 6:36 p.m.)
  • changed from pending to submitted
Committed in revision 2321

https://reviewboard.asterisk.org/ runs on a server provided by Digium, Inc. and uses bandwidth donated to the open source Asterisk community by API Digital Communications in Huntsville, AL USA.
Please report problems with this site to asteriskteam@digium.com.